Toyota Camry (XV70): Inspection
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake System (other) / Brake Booster / Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE VACUUM CHECK VALVE ASSEMBLY
| (a) Check that there is ventilation from the booster side to the engine side, and no ventilation from the engine side to the booster side of the brake vacuum check valve assembly. If the result is not as specified, replace the brake vacuum check valve assembly. |
|
READ NEXT:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL VACUUM WARNING SWITCH ASSEMBLY
(a) Install a new check valve grommet to the brake booster assembly. (b) Install the vacuum warning switch assembly to the brake booste
Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the brake booster assembly. 2. INSTALL BRAKE BOOSTER ASSEMBLY
(a) Temporarily install the brake boo
SEE MORE:
Window Defogger Wire
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. CHECK REAR WINDOW DEFOGGER OPERATION (a) When the ignition switch is ON and the rear window defogger switch is pressed, check that the window defogger system operates.
2. INSPECT REAR WINDOW DEFOGGER WIRE (BACK WINDOW GLASS)
NOTICE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna assembly removal/installation are shown below. Necessary Procedures After P
© 2023-2026 Copyright www.tocamry.com
