Toyota Camry (XV70): Calibration
CALIBRATION
NOTICE:
When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the intuitive parking assist system may not operate correctly.
ADJUST INTUITIVE PARKING ASSIST SYSTEM
(a) The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intuitive parking assist system removal/installation are shown below.
HINT:
When the bumper is removed and installed, or when the sensor is removed and installed, the registration is not required. However, if the body part is damaged or deformed due to an accident or contact, etc., and the body part is modified, measurement and registration are required.
|
Part Name | Operation |
Adjustment Item | Proceed to |
|---|---|---|---|
|
Clearance warning ECU assembly |
Replacement | Measurement of ultrasonic sensor detection angle |
|
|
Bumper type registration | |||
|
Ultrasonic sensor detection angle registration | |||
|
Ultrasonic sensor | Replacement |
Measurement of Ultrasonic sensor detection angle | |
|
Ultrasonic sensor detection angle registration | |||
|
Lower radiator grille sub-assembly |
When the radiator grile and ultrasonic sensor is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired. |
Measurement of ultrasonic sensor detection angle | |
|
Ultrasonic sensor detection angle registration | |||
|
Front bumper assembly |
When the front bumper and ultrasonic sensor is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired. |
Measurement of ultrasonic sensor detection angle | |
|
Ultrasonic sensor detection angle registration | |||
|
Rear bumper assembly |
When the rear bumper and ultrasonic sensor is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired. |
Measurement of ultrasonic sensor detection angle | |
|
Ultrasonic sensor detection angle registration |
.gif)
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the R39 clearance warning ECU assembly connector.
(b) Measure the voltage and resistance on the wire harness side connector accordin
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading v
SEE MORE:
SRS airbag instructions
for Canadian owners
(in French)
The following is a French explanation of SRS airbag instructions
extracted from the SRS airbag section in this manual.
See the SRS airbag section for more detailed SRS airbag instructions
in English.
◆ Coussins gonflables frontaux SRS
Coussin gonflable conducteur/coussin gonflable du pas
System Diagram
SYSTEM DIAGRAM FUEL FLOW DIAGRAM
*A for Direct Injection
- -
*1 Fuel Injector Assembly
*2 Throttle Body with Motor Assembly
*3 Fuel Pressure Sensor (Fuel Delivery Pipe with Sensor Assembly LH) (for High Pressure)
*4 Fuel Pressure Pulsation Damp
