Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*A | for Fold Down Seat Type |
- | - |
|
*1 | REAR SEAT CUSHION ASSEMBLY |
*2 | REAR SEAT CUSHION LOCK HOOK |
|
*3 | REAR SIDE SEATBACK ASSEMBLY LH |
*4 | REAR SIDE SEATBACK ASSEMBLY RH |
|
*5 | REAR CENTER SEAT OUTER BELT ASSEMBLY |
*6 | REAR SEAT INNER BELT ASSEMBLY RH |
|
*7 | WASHER |
- | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
ILLUSTRATION
|
*1 | ANTENNA CORD SUB-ASSEMBLY |
*2 | INNER ROOF SIDE GARNISH LH |
|
*3 | INNER ROOF SIDE GARNISH RH |
*4 | NO. 1 AMPLIFIER ANTENNA ASSEMBLY |
|
*5 | NO. 2 AMPLIFIER ANTENNA ASSEMBLY |
*6 | REAR DOOR OPENING TRIM WEATHERSTRIP LH |
|
*7 | REAR DOOR OPENING TRIM WEATHERSTRIP RH |
*8 | CLIP |
|
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● | Non-reusable part |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during am
Installation
INSTALLATION PROCEDURE 1. INSTALL ANTENNA CORD SUB-ASSEMBLY
(a) Connect the connector to install the antenna cord sub-assembly. HINT:
Use the same procedure for the RH side and LH side. 2. INSTALL
SEE MORE:
Destination Information Undefined (C1AB8)
DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced. Blind Spot Monitor Master
DTC No. Detection Item
DTC D
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE MOUNTING INSULATOR
(a) Engage the clamp and install the vacuum hose to the rear engine mounting insulator.
(b) Install the wire harness clamp bracket to the rear engine mounting insulator with the bolt.
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf}
© 2023-2026 Copyright www.tocamry.com
