Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*A | except Panoramic Moon Roof |
- | - |
|
*1 | ROOF ANTENNA ASSEMBLY |
*2 | ROOF ANTENNA ASSEMBLY WITH COVER |
|
*3 | COVER |
*4 | WASHER AND HOLDER |
|
*5 | SEAL |
*6 | ROOF ANTENNA HOUSING |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
● | Non-reusable part |
ILLUSTRATION
|
*A | for Panoramic Moon Roof |
- | - |
|
*1 | ROOF ANTENNA ASSEMBLY |
- | - |
|
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r
Installation
INSTALLATION PROCEDURE 1. INSTALL ROOF ANTENNA ASSEMBLY (except Panoramic Moon Roof)
(a) When reusing the roof antenna assembly: (1) Install a new seal.
(b) Push the roof antenna assembly in the d
SEE MORE:
Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Click here
PROCEDURE
1.
PRE-INSPECTION (a) Brake pedal inspection
(1) Perform a visual inspec
Inspection
INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR)
(a) Connect a positive (+) battery lead to connector terminal 2.
NOTICE: Do not connect a positive (+) battery lead to any terminals other than terminal 2 to avoid damaging the pulse sensor inside the
© 2023-2026 Copyright www.tocamry.com
