Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | FRONT WHEEL OPENING EXTENSION PAD RH |
*2 | FRONT WHEEL OPENING EXTENSION PAD LH |
|
*3 | NO. 1 ENGINE UNDER COVER |
*4 | NO. 2 ENGINE UNDER COVER ASSEMBLY |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
ILLUSTRATION
|
*1 | DRIVE SHAFT BEARING BRACKET |
*2 | TRANSFER CASE OIL SEAL RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● | Non-reusable part |
|
MP grease |
|
Do not apply lubricants to the threaded parts |
READ NEXT:
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced durin
COMPONENTS ILLUSTRATION
*1 FRONT WHEEL OPENING EXTENSION PAD RH
*2 FRONT WHEEL OPENING EXTENSION PAD LH
*3 NO. 1 ENGINE UNDER COVER
*4 NO. 2 ENGINE UNDER COVER AS
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
(a) Engage the 2 claws to install the automatic light control sensor. (b) Connect the connector.
2. INSTALL DEFROSTER NOZZLE ASSEMBLY Click here
3. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT Click here
4. INSTALL NO. 1
Use the overhead switches to open and close the moon roof and
tilt it up and down.
Opening and closing
Opens the moon roof*
The moon roof stops slightly before
the fully open position to reduce
wind noise.
Press the switch again to fully open
the moon roof.
Closes the moon roof*