Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
.png)
|
*1 | REAR CENTER SEAT OUTER BELT ASSEMBLY |
*2 | REAR SEAT CUSHION ASSEMBLY |
|
*3 | REAR SEAT CUSHION LOCK HOOK |
*4 | REAR SEAT INNER BELT ASSEMBLY RH |
|
*5 | WASHER |
- | - |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
ILLUSTRATION
.png)
|
*1 | FUEL PUMP GAUGE RETAINER |
*2 | FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
|
*3 | FUEL TANK MAIN TUBE SUB-ASSEMBLY |
*4 | REAR FLOOR SERVICE HOLE COVER |
|
*5 | NO. 1 FUEL TUBE CLAMP |
*6 | TUBE JOINT CLIP |
|
*7 | FUEL SUCTION TUBE SET GASKET |
*8 | BUTYL TAPE |
|
● | Non-reusable part |
- | - |
ILLUSTRATION
.png)
|
*1 | FUEL PUMP |
*2 | FUEL SENDER GAUGE ASSEMBLY |
|
*3 | FUEL SUCTION PLATE SUB-ASSEMBLY |
*4 | FUEL PUMP HARNESS |
|
*5 | FUEL SUB-TANK |
*6 | SUCTION FILTER |
|
*7 | FUEL PUMP SPACER |
*8 | FUEL FILTER |
|
*9 | HARNESS PROTECTOR |
*10 | O-RING |
|
● | Non-reusable part |
- | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
NOTICE:
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reasse
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Specified Condition
SEE MORE:
Brake Warning Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the brake system warning light (red indicator) remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the brake system warning light (red indicator) in the combination meter assembly via CAN communication. W
Terminals Of Ecu
TERMINALS OF ECU CHECK 4WD ECU ASSEMBLY
(a) Measure the voltage and resistance of the connector.
Terminal No. (Symbol) Wiring Color
Terminal Description Condition
Specified Condition
K145-6 (CANH) - K145-5 (CANL)
P - W HIGH-level CAN bus wire - LOW-level CAN bu
