Toyota Camry (XV70): Coolant
Components
COMPONENTS
ILLUSTRATION
|
*1 | RADIATOR CAP SUB-ASSEMBLY |
*2 | RADIATOR DRAIN COCK PLUG |
|
*3 | NO. 1 ENGINE UNDER COVER |
- | - |
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
CAUTION:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
.png)
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
.gif)
2. ADD ENGINE COOLANT
Click here
3. INSPECT FOR COOLANT LEAK
Click here
Components
COMPONENTS
ILLUSTRATION
.png)
|
*1 | RADIATOR CAP SUB-ASSEMBLY |
*2 | RADIATOR DRAIN COCK PLUG |
|
*3 | NO. 1 ENGINE UNDER COVER |
- | - |
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
CAUTION:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
.png)
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here
.gif)
2. ADD ENGINE COOLANT
Click here
3. INSPECT FOR COOLANT LEAK
Click here
READ NEXT:
Precaution
PRECAUTION IGNITION SWITCH EXPRESSIONS HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used
Parts Location
PARTS LOCATION ILLUSTRATION
*1 FAN WITH MOTOR ASSEMBLY - COOLING FAN MOTOR
- COOLING FAN ECU *2
ECM *3
ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - EFI-MAIN N
SEE MORE:
O2 Sensor Circuit Bank 1 Sensor 2 Circuit Short to Ground (P013611,...,P015623)
DESCRIPTION In order to obtain a high purification rate of the carbon monoxide (CO), hydrocarbon (HC) and nitrogen oxide (NOx) components in the exhaust gas, a TWC (Three-Way Catalytic Converter) is used. For the most efficient use of the TWC, the air fuel ratio must be precisely controlled so that
Calibration
CALIBRATION
NOTICE:
Initial AWD functions such as acceleration are sometimes affected unless backup memory is cleared.
When the yaw rate and acceleration sensor (airbag sensor assembly) is replaced, Reset Memory must be performed.
RESET MEMORY (a) Turn the ignition switch off. (b) Co
