Toyota Camry (XV70): Customize Parameters
CUSTOMIZE PARAMETERS
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
CUSTOMIZE ROAD SIGN ASSIST SYSTEM
(a) Customizing with the multi-information display
(1) Turn the ignition switch to ON.
(2) Select the setting by referring to the table below.
(3) Using the steering pad switches, change the customize settings.
HINT:
Each item is displayed on the "Setting" tab on the multi-information display.
Road Sign Assist Setup|
Display | Description |
Setting | Default |
Relevant ECU | |
|---|---|---|---|---|---|
| *: Display contents differ depending on the country. | |||||
| RSA |
Road sign assist function setting |
On / Off | On |
Forward recognition camera | |
|
Notification Method* |
Excess speed | Excess speed notification method setting |
No Notification / Only Visual / Visual & Audio |
Only Visual | Forward recognition camera |
|
Others | Other notification method setting |
No Notification / Only Visual / Visual & Audio |
Only Visual | Forward recognition camera | |
|
Notification Level | Excess speed notification level setting |
10 km/h (5 MPH) / 5 km/h (3 MPH) / 2 km/h (1 MPH) |
2 km/h (1 MPH) | Forward recognition camera | |
READ NEXT:
Utility
UTILITY NOTICE: If the forward recognition camera has been replaced due to a malfunction in the road sign assist system, be sure to perform forward recognition camera adjustment. Otherwise all systems
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
SEE MORE:
Shift Lever Knob
ComponentsCOMPONENTS ILLUSTRATION
*1 SHIFT LEVER KNOB SUB-ASSEMBLY
- - RemovalREMOVAL PROCEDURE
1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Disengage the 2 claws to disconnect the shifting hole cover sub-assembly as shown in the illustration.
(
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT PROCEDURE
1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG (a) Temporarily install the front disc brake bleeder plug to the front disc brake cylinder.
HINT: Fully tighten the front disc brake bleeder plug after bleeding the system.
2. INSTALL FRONT DISC B
