Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Fuel Lid Opener Switch |
Fuel lid opener switch status |
OFF or ON | OFF: Fuel lid opener switch not pushed ON: Fuel lid opener switch pushed |
- |
| Trunk / Fuel Opener SW Operation Setting |
Operation method of opening the fuel lid |
Short or Long | Customize setting displayed |
- |
ACTIVE TEST
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Main Body > Active Test|
Tester Display | Measurement Item |
Control Range | Diagnostic Note |
|---|---|---|---|
|
Fuel Lid Opener | Fuel lid lock with motor assembly |
OFF/ON | - |
READ NEXT:
Fuel Lid Opener does not Operate
DESCRIPTION When the fuel lid opener switch is pushed for 0.8 second, the main body ECU (multiplex network ECU) turns on the FUEL OPN relay, and the fuel lid lock with motor assembly opens the fuel li
Components
COMPONENTS ILLUSTRATION
*1 HOOD INSULATOR
*2 HOOD STAY BRACKET RH
*3 HOOD STAY HOLDER
*4 HOOD SUPPORT ASSEMBLY
*5 HOOD TO RADIATOR SUPPORT SEAL
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT OIL PUMP ASSEMBLY
(a) Install the oil pump drive shaft sub-assembly to the front oil pump assembly.
NOTICE:
To avoid damaging the bush of the front oil pump assembly, install the oil pump drive shaft sub-assembly perpendicularly relative to the fr
Regulations on the use of tire chains
Regulations regarding the use of tire chains vary depending on location
and type of road. Always check local regulations before installing
chains.
■Tire chain installation
Observe the following precautions when installing and removing chains:
Install and remove tire chains in a safe locati
