Toyota Camry (XV70): Hood
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 HOOD INSULATOR
*2 HOOD STAY BRACKET RH
*3 HOOD STAY HOLDER
*4 HOOD SUPPORT ASSEMBLY
*5 HOOD TO RADIATOR SUPPORT SEAL
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas a through e are within each standard range.
Standard Clearance
Area Meas
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE HOOD TO RADIATOR SUPPORT SEAL
(a) Using a clip remover, disengage the 10 hood to radiator support seal clips to remove the hood to radiator support seal.
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below. Necessary Procedures After Parts Removed/In
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane tracing assist system, a message is displayed on the multi-information display and control is canceled in accordance with the malfunction.
Warning Message
Cause Fail-safe Operation
Conditions to Return to
© 2023-2026 Copyright www.tocamry.com
