Toyota Camry (XV70): Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
|
*a | Centering Bolt |
|
*b | Standard Bolt |
HINT:
- Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts with washers when making adjustments.
- The specified torque for standard bolts is shown in the standard bolt chart.
Click here
.gif)
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
Click here
2. ADJUST HOOD SUB-ASSEMBLY
(a) Horizontally and vertically adjust the hood.
| (1) Loosen the 4 hinge bolts of the hood. |
|
(2) Adjust the clearance between the hood and front fenders by moving the hood.
(3) Tighten the 4 hinge bolts after adjustment.
Torque:
13 N
READ NEXT:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL HOOD STAY BRACKET RH
(a) Engage the guide.
(b) Install the hood stay bracket RH with the bolt. 2. INSTALL HOOD SUPPORT ASSEMBLY
(a) En
Components
COMPONENTS ILLUSTRATION
*1 COOL AIR INTAKE DUCT SEAL
*2 COWL SIDE TRIM SUB-ASSEMBLY LH
*3 FRONT DOOR SCUFF PLATE LH
*4 FRONT FENDER LINER LH
*5 F
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT TURN SIGNAL SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: Light Control Switch
Tester Connection
Condition Specified Condition
*1: w/ Light Control Switch DRL OFF Position
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT LED (for Bulb Type Back-up Light)
*a Component without harness connected
(Rear Combination Light LED) (a) Apply battery voltage to the rear combination light LED and check that the lights illuminate.
OK:
Conditi
© 2023-2026 Copyright www.tocamry.com
