Toyota Camry (XV70): Hood Lock Control Cable Assembly
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Door / Hatch / Hood Lock Control Cable Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 COOL AIR INTAKE DUCT SEAL
*2 COWL SIDE TRIM SUB-ASSEMBLY LH
*3 FRONT DOOR SCUFF PLATE LH
*4 FRONT FENDER LINER LH
*5 F
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL LH
Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
HINT: Use the same procedure as for the RH side. Click here
3. REMOVE FRONT FENDER LIN
Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet. (c) Engage the 4 clamps to i
SEE MORE:
Components
COMPONENTS ILLUSTRATION
*A w/ Dust Cap
- -
*1 FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH)
*2 FUEL PIPE PLUG SUB-ASSEMBLY
*3 DUST CAP SUB-ASSEMBLY
*4 O-RING
*5 NO. 1 FUEL INJECTOR BACK-UP RING
*6 NO. 2 FUE
Precaution
PRECAUTION IGNITION SWITCH EXPRESSIONS HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression Ignition Switch (Position)
Engine Switch (Condition)
© 2023-2026 Copyright www.tocamry.com
