Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Main Body > Active Test|
Tester Display | Measurement Item |
Control Range | Diagnostic Note |
|---|---|---|---|
|
Vehicle Horn | Vehicle horn |
OFF / ON | - |
READ NEXT:
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT HORN RELAY
*a Component without harness connected (HORN Relay)
(a) Measure the resistance according to the valu
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communication system.
*: Use the Techstream.
PROCEDURE
1. VEHICLE BROUGHT TO WORKSHOP
Blind Spot Monitor Sensor
ComponentsCOMPONENTS ILLUSTRATION
*1 BLIND SPOT MONITOR SENSOR LH
*2 BLIND SPOT MONITOR SENSOR RH
*3 REAR BUMPER ASSEMBLY
- -
N*m (kgf*cm, ft.*lbf) : Specified torque
- - RemovalREMOVAL CAUTION / NOTICE / HINT
The necessary procedures
