Toyota Camry (XV70): Automatic High Beam Main Switch
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Lighting (ext) / Automatic High Beam Main Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 AUTO HIGH BEAM SWITCH
*2 COWL SIDE TRIM SUB-ASSEMBLY LH
*3 FRONT DOOR OPENING TRIM WEATHERSTRIP LH
*4 FRONT DOOR SCUFF PLATE LH
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. REMOVE NO. 1 INSTRUMEN
Inspection
INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH
*a Component without harness connected
(Auto High Beam Switch) (a) Measure the resistance according to the value(s) in the
SEE MORE:
4WD Control ECU Communication Stop Mode
DESCRIPTION
Detection Item Symptom
Trouble Area 4WD Control ECU Communication Stop Mode
Any of the following conditions are met:
Communication stop for "Four Wheel Drive Control" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Terminals Of Ecu
TERMINALS OF ECU CHECK SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
*a Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly))
- -
(a) Disconnect the A34 skid control ECU (brake actuator assembly) connector.
(b) Measure the voltage and resistance
© 2023-2026 Copyright www.tocamry.com
