Toyota Camry (XV70): Diagnosis System
Toyota Camry Repair Manual XV70 (2018-2024) / Power Source, Network / 2gr-fks (battery / Charging) / Charging System / Diagnosis System
DIAGNOSIS SYSTEM
DLC3 (Data Link Connector 3)
(a) Check the DLC3.
Click here .gif)
BATTERY VOLTAGE
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery.
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG). (c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Trouble Cod
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in deter
Fail-safe Chart
FAIL-SAFE CHART If the following DTC is stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
DTC No. Fail-safe Operation
Fail-safe Deactivation Condition
SEE MORE:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA/INFORMATION
(a) Using the Techstream, check the vehicle condition (ECU, sensor) when the brake system operates or a DTC is output.
CHECK FREEZE FRAME DATA AND INFORMATION WHEN DTC WAS STORED (a) Freeze Frame Data is stored when a DTC is output.
(b) Once Free
Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet. (c) Engage the 4 clamps to install the hood lock control cable assembly.
(d) Engage the clamp. 2. INSTALL HOOD LOCK CONTROL L
© 2023-2026 Copyright www.tocamry.com
