Toyota Camry owners & service manuals

Toyota Camry (XV70): Driving procedures

READ NEXT:

 Engine (ignition) switch (vehicles without a smart key system)

Starting the engine 1. Check that the parking brake is set. 2. Check that the shift lever is in P. 3. Firmly depress the brake pedal. 4. Turn the engine switch to the "START" position and start th

 Engine (ignition) switch (vehicles with a smart key system)

Performing the following operations when carrying the electronic key on your person starts the engine or changes engine switch modes. Starting the engine 1. Check that the parking brake is set. 2

 Changing engine switch modes

Modes can be changed by pressing the engine switch with the brake pedal released. (The mode changes each time the switch is pressed.) Off* The emergency flashers can be used. The multi-info

SEE MORE:

 Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)

CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization. Click here PROCEDURE 1. PRE-INSPECTION (a) Brake pedal inspection (1) Perform a visual inspec

 ECM Power Source Circuit

DESCRIPTION When the engine switch is turned on (IG), the battery voltage is applied to the IGSW terminal of the ECM. The output signal from the MREL terminal of the ECM causes a current to flow to the coil of the EFI-MAIN NO. 1 relay, closing the contacts and supplying power to terminals +B and +

© 2023-2026 Copyright www.tocamry.com