Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Steering / Power Assist Systems / Power Steering System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTCs (USING TECHSTREAM)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Trouble Codes.

Chassis > EMPS > Trouble Codes

(f) Check the details of the DTCs.

Click here

CLEAR DTCs (USING TECHSTREAM)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Trouble Codes.

Chassis > EMPS > Trouble Codes

(f) Clear the DTCs.

Chassis > EMPS > Clear DTCs

(g) Turn the ignition switch off.

(h) Disconnect the Techstream from the DLC3.

    READ NEXT:

     Freeze Frame Data

    FREEZE FRAME DATA FREEZE FRAME DATA NOTICE: It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in

     Fail-safe Chart

    FAIL-SAFE CHART If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system. Power Steering System

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts.

    SEE MORE:

     GPS Mark is not Displayed

    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System. w/o Navigation System: Click here w/ Navigation Sys

     Installation

    INSTALLATION PROCEDURE 1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (for 2WD) (a) Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut. NOTICE: Because the nut has its own stopper, do not turn the nut. Tighten the

    © 2023-2026 Copyright www.tocamry.com