Toyota Camry (XV70): Emission Control System
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (emission Control) / Emission Control System
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 CANISTER (CHARCOAL CANISTER ASSEMBLY)
*2 FUEL TANK CAP ASSEMBLY
*3 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
*4 PURGE VALVE (PURGE
System Diagram
SYSTEM DIAGRAM
*1 Purge Valve (Purge VSV)
*2 Fuel Tank Cap Assembly
*3 Fuel Tank Assembly
*4 Canister Filter
*5 Fuel Cut-off Valve
*6 ECM
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT FUEL CUT OPERATION (a) Start the engine. (b) Warm up the engine.
(c) Increase the engine speed to approximately 3500 rpm. (d) Use a sound scope to check
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP
HINT: Perform the following procedure only when replacement of a No. 3 windshie
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER)
(a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON. (d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes. Cha
© 2023-2026 Copyright www.tocamry.com
