Toyota Camry (XV70): Fail-safe Chart
FAIL-SAFE CHART
FAIL-SAFE FUNCTION
(a) When a malfunction occurs in the road sign assist system, a message will be displayed on the multi-information display and the road sign assist system will be disabled, depending on the malfunction.
|
Warning Message | Malfunction Status |
Fail-safe Operation | DTC/Vehicle Control History (RoB) |
Fail-safe Mode Deactivation Condition |
|
X: Control is suspended
|
| "RSA Malfunction Visit Your Dealer" |
Road sign assist system is malfunctioning |
X | Stored |
After system returns to normal, ignition switch is turned off and then to ON |
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
DIAGNOSTIC TROUBLE CODE CHART Road Sign Assist System
DTC No. Detection Item
Link U010087
Lost Communication with ECM/PCM "A" Missing Message
U012587 Lost Com
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
CHECK VEHICLE CONTROL HISTORY (ROAD
SEE MORE:
COMPONENTS ILLUSTRATION
*1 GENERATOR ASSEMBLY
*2 WIRE HARNESS CLAMP BRACKET
*3 GENERATOR ASSEMBLY BRACKET
*4 V-BANK COVER SUB-ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kg
COMPONENTS ILLUSTRATION
*1 REAR ENGINE OIL SEAL
*2 NO. 1 CRANKSHAFT POSITION SENSOR PLATE
*3 DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
*4 REAR DRIVE PLATE SPACER
N*m (kgf*cm, ft.*lbf): Specified torque
● Non-reusable part