Toyota Camry (XV70): Freeze Frame Data
FREEZE FRAME DATA
FREEZE FRAME DATA
(a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes(e) Select a DTC to display its freeze frame data.
Body Electrical > Front Recognition Camera (Front Lighting Control)|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Actual driven distance |
0 to 16777215 | Roughly the same as the actual driven distance |
- |
| Total Distance Traveled - Unit |
Actual driven distance unit |
km or mile | Displays the current actual driven distance unit |
- |
| AHB/AHS Information |
Automatic high beam system or adaptive high beam system specification information |
Unknown, AHB or AHS |
Unknown: Specification not stored AHB: w/ Automatic High Beam System AHS: w/ Adaptive High Beam System |
- |
CLEAR FREEZE FRAME DATA
NOTICE:
Clearing the DTCs will also clear the freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Clear DTCs.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs(e) Clear the DTCs and freeze frame data.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lighting System
DTC No. Detection Item
DTC Output from Link
B1244 Light Sensor Circuit
Main Body
B124B Automatic H
Vehicle Control History
VEHICLE CONTROL HISTORY CHECK VEHICLE CONTROL HISTORY
HINT:
The vehicle control history data stores the history of the reject function and system protection operations.
The number of o
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
(a) Check the valve opening. HINT: The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly.
(1) Add 15 cc (0.9 cu. in.) of water to the water inlet with thermostat sub-assembly from
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SPOILER RETAINER (except TRD)
HINT: When installing a new rear spoiler retainer, heat the luggage compartment door panel and rear spoiler retainer using a heat light. Heating Temperature
Item Temperature
Luggage Compartment Door Panel
