Toyota Camry (XV70): Lighting System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Light Sensor Circuit (B1244)
- Automatic High Beam System (B124B)
- Automatic High Beam Camera (B124C)
- LED Headlight LH (B2430,B2431)
- Lost Communication With ECM/PCM "A" (U0100,U0101,U0120,U0126,U0129,U0151,U0155,U0163,U0164,U023A,U0327,U1106,U1117)
- Lost Communication With ECM/PCM "A" Missing Message (U010087,U012587,U012987,U014087)
- Lost Communication with Cruise Control Front Distance Range Sensor Signal Sensor or Center Missing Message (U023587)
- Turn Signal Switch Circuit
- Automatic High Beam Switch Indicator does not Come ON
- Automatic High Beam System does not Operate or Operation Indicator does not Illuminate
- Headlight Dimmer Switch Circuit
- Daytime Running Light Circuit
- Hazard Warning Switch Circuit
- LO-beam Headlight does not Illuminate
- Parking Brake Switch Circuit
- Taillight Relay Circuit
- High Beam Headlight Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the
Parts Location
PARTS LOCATION ILLUSTRATION
*A w/ Side Turn Signal Light
*B for A25A-FKS
*C for 2GR-FKS
- -
*1 HEADLIGHT ASSEMBLY LH
*2 HEADLIGHT ASSEMB
System Diagram
SYSTEM DIAGRAM
HEADLIGHT ASSEMBLY CIRCUIT (for Bulb Type Turn Signal Light)
HEADLIGHT ASSEMBLY CIRCUIT (for LED Type Turn Signal Light)
SEE MORE:
Position Initialization Incomplete (B2343)
DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) has not been initialized. Sliding Roof
DTC No. Detection Item
DTC Detection Condition
Trouble Area
B2343 Position Initia
Installation
INSTALLATION PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1)
HINT: Perform "Inspection After Repair" after replacing the air fuel ratio sensor.
Click here
(a) Using SST, install the air fuel ratio sensor to the exhaust manifold assembly RH (TWC: Front Catalyst).
SST: 09224
© 2023-2026 Copyright www.tocamry.com
