Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Lighting (ext) / Lighting System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Main Body > Trouble Codes Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes

(e) Check for DTCs.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Main Body > Clear DTCs Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs

(e) Clear the DTCs.

    READ NEXT:

     Freeze Frame Data

    FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) C

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Lighting System DTC No. Detection Item DTC Output from Link B1244 Light Sensor Circuit Main Body B124B Automatic H

    SEE MORE:

     Wiper and Washer Switch Circuit

    DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Te

     Removal

    REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH Click here 2. DRAIN ENGINE OIL Click here 3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector

    © 2023-2026 Copyright www.tocamry.com