Toyota Camry (XV70): Front Drive Shaft Assembly (for A25a-fks)
READ NEXT:
COMPONENTS ILLUSTRATION
*1 FRONT FENDER APRON SEAL LH
*2 FRONT FENDER APRON SEAL RH
*3 FRONT WHEEL OPENING EXTENSION PAD LH
*4 FRONT WHEEL OPENING EXTENSION PAD R
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f
DISASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD J
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR UPPER COIL SPRING INSULATOR
(a) Install the rear upper coil spring insulator to the vehicle. 2. INSTALL REAR LOWER COIL
DIAGNOSTIC TROUBLE CODE CHART Automatic Transaxle System
DTC No. Detection Item
MIL Memory
Note Link
P050031 Vehicle Speed Sensor "A" No Signal
Comes on DTC stored
SAE Code: P0500
P056014 System Voltage Circuit Short to Ground or Open