Toyota Camry (XV70): Initialization
INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Press the OFF switch.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(f) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility|
Tester Display |
|---|
| Servomotor Initialization |
HINT:
When initialization is started, the AUTO switch indicator will illuminate and then will turn off when initialization has completed.
(g) Select Exit to complete initialization.
READ NEXT:
Utility
UTILITY REFRIGERANT HIGH PRESSURE HISTORY CLEAR
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON.
(c) Press the OFF switch. (d) Turn the Techstream on. (e) Enter the follow
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
*A w/o Seat Heater
*B w/ Seat Heater
*C for Dual Type
*D for Single Type
HINT:
Check from the rear of t
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the LIN communication system.
*: Use the Techstream.
PROCEDURE
1. VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
HINT:
In troubleshoot
Brake System Control Module "A" System Internal Failure (C059704)
DESCRIPTION The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self diagnosis.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C059704 Brake System Control Module "A" System Internal Failure
© 2023-2026 Copyright www.tocamry.com
