Toyota Camry (XV70): Air Conditioning System (for Automatic Air Conditioning System)
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System (for Automatic Air Conditioning System)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Initialization
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Room Temperature Sensor Circuit (B1411)
- Ambient Temperature Sensor Circuit (B1412)
- Evaporator Temperature Circuit or Evaporator Fin Thermistor (B1413)
- Compressor Lock (B1422)
- Open in Pressure Sensor Circuit / Abnormal Refrigerant Pressure (B1423)
- Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441)
- Air Inlet Damper Control Servo Motor Circuit (B1442)
- Air Outlet Damper Control Servo Motor Circuit (B1443)
- Air Mix Damper Control Servo Motor Circuit (Driver Side) (B1446)
- Air Outlet Damper Control Servo Motor Circuit (Rear) (B1449)
- Compressor Solenoid Circuit (B1451)
- Communication Malfunction (Bus Ic) (B1497)
- Lost Communication with Front Panel LIN (B14B2)
- Refrigerant Shortage (B14B8)
- Refrigerant Overabundance Filling Malfunction (B14BD)
- Lost Communication With ECM/PCM "A" (U0100-U0142,U0151,U0155)
- Blower Motor Circuit
- Air Conditioning Compressor Magnetic Clutch Circuit
- Ambient Temperature Display System
- ECO Switch Circuit
- Indicator does not Illuminate
- Cooling System
- Operation not Accepted Even If Air Conditioning Switch is Operated
- Front Window Fogging
- Blower Motor does not Operate
- Weak Blower Output
- Pressure Sensor Circuit
- Recirculated/Fresh Air Modes do not Switch
- No Cool Air Comes Out
- Air Vent cannot be Switched
- Air Vent Temperature does not Change and Right Vent is Different from Left and Vice Versa (Same Left/Right Temperature Setting)
- No Warm Air Comes Out
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the ca
Parts Location
PARTS LOCATION ILLUSTRATION
*A for A25A-FKS
*B for 2GR-FKS
*1 AIR CONDITIONER PRESSURE SENSOR
*2 THERMISTOR ASSEMBLY
*3 COOLER CONDENSER ASSEMBLY
*4 POW
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Repl
Installation
INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL LEVEL SENSOR
(a) Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (b) Install a new clip to the engine oil level sensor.
2. INSTALL OIL STRAINER SUB-ASSEMBLY Click here
3.
© 2023-2026 Copyright www.tocamry.com
