Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE OIL LEVEL SENSOR
(a) Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(b) Install a new clip to the engine oil level sensor.
2. INSTALL OIL STRAINER SUB-ASSEMBLY
Click here
.gif)
3. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Click here
4. REMOVE ENGINE ASSEMBLY FROM ENGINE STAND
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 ENGINE OIL PRESSURE SWITCH ASSEMBLY
*2 FRONT FENDER APRON SEAL RH
*3 WIRE HARNESS PROTECTOR
- -
N*m (kgf*cm, ft*lbf): Sp
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH
Click here
2. DRAIN ENGINE OIL Click here
3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp to disco
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Front Camera System
DTC No. Detection Item
Link C10001C
Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range
C10051C Control Module Internal Temperature Sensor "B" Circuit Circuit Voltage Out of Ra
Installation
INSTALLATION PROCEDURE 1. PRECAUTION (w/o Navigation System)
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
A communicatio
© 2023-2026 Copyright www.tocamry.com
