Toyota Camry (XV70): Front Turn Signal Light Bulb
Components
COMPONENTS
ILLUSTRATION
|
*1 | FRONT TURN SIGNAL LIGHT BULB |
- | - |
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT TURN SIGNAL LIGHT BULB
(a) Turn the headlight cord with the front turn signal light bulb as shown in the illustration to disconnect them as a unit.
|
Remove in this Direction |
(b) Remove the front turn signal light bulb from the headlight cord.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT TURN SIGNAL LIGHT BULB
(a) Install the front turn signal light bulb to the headlight cord.
(b) Turn the headlight cord with the front turn signal light bulb as shown in the illustration to connect them as a unit.
|
Install in this Direction |
READ NEXT:
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT WIPER BLADE
*2 WIPER RUBBER
*3 FRONT WIPER RUBBER BACKING PLATE
- - RemovalREMOVAL CAUTION / NOTICE / HINT
NOTICE:
OUTSIDE VEHICLE
These are maintenance and inspection items that are considered to be the owner's responsibility.
The owner can do them or they can have them done at a service center.
These it
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY
(a) Check the operation of the fuel lid lock with motor assembly (motor operation).
(1) Apply battery voltage to the fuel lid lock with motor assembly connector, and check the operation of the fuel lid lock with motor assembly.
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
1. Stop the engine. Set the parking brake and shift the shift lever to P.
2. Remove the mud, snow or sand from around the front wheels.
3. Place wood, stones or some other material under the f