Toyota Camry owners & service manuals

Toyota Camry (XV70): General maintenance

Periodic maintenance / General maintenance

Explanation of general maintenance

General maintenance includes those items which should be checked during the normal day-to-day operation of the vehicle. They are essential if the vehicle is to continue operating properly. The owners can perform checks and inspections themselves or have their nissan dealers do them.

Outside the vehicle

The maintenance items listed here should be performed from time to time, unless otherwise specified.

Inside the vehicle


Inside the vehicle

The maintenance items listed here should be checked on a regular basis, such as when performing periodic maintenance, cleaning the vehicle, etc.


Under the hood and vehicle


Under the hood and vehicle

The maintenance items listed here should be checked periodically (e.G. Each time you check the engine oil or refuel).

Periodic maintenance


    READ NEXT:

     Periodic maintenance

    Introduction of periodic maintenance The following tables show the normal maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits

     Recommended fluids and lubricants

    Fluids and lubricants *1: For additional information, see “engine oil recommendation”. *2: As an alternative to this recommended oil, sae 5w-30 conventional petroleum based oil may

     Engine maintenance

    Drive belt Drive belt : inspection Alternator Drive belt auto-tensioner Crankshaft pulley A/c compressor Water pump Drive belt Possible use range New drive belt range Ndica

    SEE MORE:

     Internal Control Module Throttle Position Performance Internal Electronic Failure (P060E49,P061E49)

    MONITOR DESCRIPTION The ECM monitors the signals received from the No. 1 throttle position sensor and stop light switch assembly. As the ECM monitors the STP signal of the stop light switch assembly and the VTA1 signal of the No. 1 throttle position sensor, if these signals do not correlate, a DTC w

     Installation

    INSTALLATION PROCEDURE 1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (for 2WD) (a) Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut. NOTICE: Because the nut has its own stopper, do not turn the nut. Tighten the

    © 2023-2026 Copyright www.tocamry.com