Toyota Camry (XV70): Head restraints
Head restraints are provided for all seats.
Adjustable type
- Up
Pull the head restraint up. - Down
Push the head restraint down while pressing the lock release button.
Integrated type
Head restraints cannot be adjusted or removed.
■Removing the head restraints
Pull the head restraint up while pressing the lock release button.
Front seats: If the head restraint touches the ceiling, making the removal difficult, change the seat height or angle.
■Installing the head restraints
Front seats
Align the head restraint with the installation holes and push it down to the lock position.
Press and hold the lock release button when lowering the head restraint.
Rear seats
Align the head restraint with the installation holes and push it down to the lowest lock position while pressing the lock release button.
■Adjusting the height of the head restraints
Make sure that the head restraints are adjusted so that the center of the head restraint is closest to the top of your ears.
WARNING
■Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to do so may result in death or serious injury.
- Use the head restraints designed for each respective seat.
- Adjust the head restraints to the correct position at all times.
- After adjusting the head restraints, push down on them and make sure they are locked in position.
- Do not drive with the head restraints removed.
READ NEXT:
Steering wheel
Adjustment procedure
1. Hold the steering wheel and
push the lever down.
2. Adjust to the ideal position by
moving the steering wheel horizontally
and vertically.
After adjustment, pull the
Inside rear view mirror
The rear view mirror's position can be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view mirror
The height of the rear view mirror can be adjusted to su
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER STRAIGHT PIN
(a) Secure the brake master cylinder sub-assembly in a vise. NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
(b) Using a 5 mm pin punch and a hammer, tap out the brake
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA
NOTICE:
It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem
