Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
(a) With the speaker installed, check that there is no looseness or other abnormalities.
(b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
| (c) Measure the resistance of the speaker. Standard Resistance: for 6 Speakers |
Tester Connection | Condition |
Specified Condition | |
1 - 2 | Always |
3.2 to 4.8 Ω | for 9 Speakers |
Tester Connection | Condition |
Specified Condition | |
1 - 2 | Always |
4.5 to 6.7 Ω | If the result is not as specified, replace the speaker. |
|
|
*a | Component without harness connected
(Front No. 1 Speaker Assembly) | | |
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT NO. 1 SPEAKER ASSEMB
COMPONENTS ILLUSTRATION
*1 FRONT DOOR OPENING TRIM WEATHERSTRIP
*2 FRONT NO. 2 SPEAKER ASSEMBLY
*3 FRONT PILLAR GARNISH
*4 NO. 1 INSTRUMENT PANEL SPEAKER PANEL
SEE MORE:
CAUTION / NOTICE / HINT PRECAUTIONS WHEN TROUBLESHOOTING
NOTICE:
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
If the CAN communica
INSPECTION PROCEDURE 1. INSPECT BRAKE CYLINDER AND PISTON
(a) Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the front disc brake cylinder assembly and front disc brake piston.
2. INSPECT PAD LINING THICKNESS
(a) Using a rul