Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT DIFFERENTIAL CASE ASSEMBLY
| (a) Using SST, rotate the front differential side gear as shown in the illustration.
SST: 09528-52010 09528-05030 Standard: The front differential side gear does not lock when rotated in either direction.
If the result is not as specified, replace the differential case assembly. |
|
READ NEXT:
REASSEMBLY PROCEDURE 1. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING (INNER RACE)
(a) Using SST and a press, install a new front differential case front tapered roller bearing (i
ComponentsCOMPONENTS ILLUSTRATION
*1 DRIVE SHAFT BEARING BRACKET
*2 FRONT DRIVE SHAFT OIL SEAL LH
*3 FRONT DRIVE SHAFT OIL SEAL RH
- -
N*m (kgf*cm,
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
(a) Install the front lower arm bushing stopper to the front lower No. 1 suspe
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) With the ignition switch ON and the wheels not contacting the ground, operate the electric parking brake switch assembly to check the condition of the rear wheels when the electric parking brake is operating and not ope