Toyota Camry (XV70): Inspection
Toyota Camry Repair Manual XV70 (2018-2024) / Steering / Steering Column / Steering Heater Switch / Inspection
INSPECTION
PROCEDURE
1. INSPECT STEERING HEATER SWITCH
| (a) Remove the steering heater switch. Click here
|
|
.gif)
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
5 (IG) - 2 (B) | Steering heater switch is pushed |
Below 1 Ω |
|
5 (IG) - 2 (B) | Steering heater switch is not pushed |
10 kΩ or higher |
(c) Indicator Inspection
(1) Apply battery voltage to the steering heater switch and check that the indicator illuminates.
OK:
|
Condition | Specified Condition |
|---|---|
|
Battery positive (+) → Terminal 2 (B) Battery negative (-) → Terminal 4 (E) |
Illuminates |
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING HEATER SWITCH
(a) Engage the 2 claws to install the steering heater switch as shown in the illustration.
Install in this Direction
Components
COMPONENTS ILLUSTRATION
*1 STEERING PAD SWITCH ASSEMBLY
- -
SEE MORE:
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION The radio and display receiver assembly, roof console box sub-assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
DTC
Inspection
INSPECTION PROCEDURE 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
(a) Using a vernier caliper, measure the length of the exposed brushes.
Standard Exposed Brush Length: 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum Exposed Brush Length: 4.5 mm (0.177 in.) If the brush length is less than t
© 2023-2026 Copyright www.tocamry.com
