Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Steering / Steering Column / Steering Heater Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING HEATER SWITCH
(a) Engage the 2 claws to install the steering heater switch as shown in the illustration.
.png) |
Install in this Direction |
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here .gif)
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 2 METER HOOD CLUSTER
Click here
5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. INSTALL INSTRUMENT SIDE PANEL LH
Click here
7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
9. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 STEERING PAD SWITCH ASSEMBLY
- -
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during
SEE MORE:
Back-up Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE LUGGAGE COMPARTMENT DOOR COVER
Click here
2. REMOVE BACK-UP LIGHT BULB
Click here 3. INSTALL BACK-
Check Bus 2 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and termin
© 2023-2026 Copyright www.tocamry.com
