Toyota Camry (XV70): Utility
UTILITY
REFRIGERANT HIGH PRESSURE HISTORY CLEAR
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Press the OFF switch.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Air Conditioner / Utility / Refrigerant High Pressure History Clear.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Refrigerant High Pressure History Clear |
REFRIGERANT SHORTAGE CHECK USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Utility / Refrigerant Gas Volume Check.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Refrigerant Gas Volume Check |
(e) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the Techstream.
Measurement Condition:
|
Item | Condition |
|
A/C switch | On |
|
Ambient temperature* |
0 to 49°C (32 to 120°F) |
|
Blower speed | HI |
*: If the ambient temperature is not within the range shown, do not perform this check.
HINT:
- Refer to the Techstream operator's manual for further details.
- A message indicating a refrigerant shortage is displayed on the Techstream and the air conditioning system turns off if the amount of refrigerant in the system is insufficient.
- DTCs are not stored when performing the refrigerant shortage check using the Techstream.
Result:
|
Result | Amount of Refrigerant |
Corrective Action |
|
Refrigerant shortage |
Insufficient |
- Check for refrigerant leaks using a halogen leak detector, and repair if necessary.
- Evacuate the air conditioning system and charge it with the appropriate volume of new or purified refrigerant.
Click here
|
| Refrigerant correct |
Correct | - |
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
*A w/o Seat Heater
*B w/ Seat Heater
HINT:
Check from the rear of the connector while it is connected to the air condit
DIAGNOSIS SYSTEM DESCRIPTION Air conditioning system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfuncti
SEE MORE:
DESCRIPTION The fuel sender gauge is located inside the fuel tank and measures the amount of fuel. The fuel sender gauge converts the fuel level in the fuel tank into a voltage value and outputs it to the combination meter assembly. The ECM determines when it is necessary to refuel the vehicle based
4.2-inch display
7-inch display
Tachometer
Displays the engine speed in revolutions per minute
Shift position
Outside temperature
Displays the outside temperature within the range of -40ºF (-40ºC) to
122ºF (50ºC). Low outside temperature indicator comes on when the
ambient