Toyota Camry (XV70): Air Conditioning System (for Manual Air Conditioning System)
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System (for Manual Air Conditioning System)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Initialization
- Utility
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Ambient Temperature Sensor Circuit (B1412)
- Evaporator Temperature Circuit or Evaporator Fin Thermistor (B1413)
- Open in Pressure Sensor Circuit / Abnormal Refrigerant Pressure (B1423)
- Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441)
- Air Inlet Damper Control Servo Motor Circuit (B1442)
- Air Outlet Damper Control Servo Motor Circuit (B1443)
- Compressor Solenoid Circuit (B1451)
- Communication Malfunction (Bus Ic) (B1497)
- Lost Communication with Front Panel LIN (B14B2)
- Refrigerant Shortage (B14B8)
- Refrigerant Overabundance Filling Malfunction (B14BD)
- Lost Communication With ECM/PCM "A" (U0100-U0142,U0151,U0155)
- Blower Motor Circuit
- Ambient Temperature Display System
- Indicator does not Illuminate
- Cooling System
- Operation not Accepted Even If Air Conditioning Switch is Operated
- Front Window Fogging
- Blower Motor does not Operate
- Weak Blower Output
- Pressure Sensor Circuit
- Recirculated/Fresh Air Modes do not Switch
- No Cool Air Comes Out
- Air Vent cannot be Switched
- No Warm Air Comes Out
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the ca
Parts Location
PARTS LOCATION ILLUSTRATION
*1 AIR CONDITIONER PRESSURE SENSOR
*2 THERMISTOR ASSEMBLY
*3 COOLER CONDENSER ASSEMBLY
*4 RACK AND PINION POWER STEERING GEAR ASSEMBLY (POWE
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Stereo Jack Adapter Assembly
ComponentsCOMPONENTS ILLUSTRATION
*1 LOWER CENTER INSTRUMENT PANEL FINISH PANEL
*2 NO. 1 METER HOOD CLUSTER
*3 NO. 1 STEREO JACK ADAPTER ASSEMBLY
- - RemovalREMOVAL PROCEDURE
1. REMOVE NO. 1 METER HOOD CLUSTER Click here
2. REMOVE LOWER CENTER IN
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
5 (SS1) - 6 (AGND) 1 (SS2) - 6 (AGND)
Not p
© 2023-2026 Copyright www.tocamry.com
