Toyota Camry owners & service manuals

Toyota Camry (XV70): Recirculated/Fresh Air Modes do not Switch

Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System (for Manual Air Conditioning System) / Recirculated/Fresh Air Modes do not Switch

DESCRIPTION

If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following suspected areas may be the cause.

Symptom

Factor
  • Air inlet mode cannot be changed between recirculation/fresh
  • Exhaust gas odors can be smelled when air inlet mode set to recirculation mode
  • No. 1 blower damper servo sub-assembly malfunction
  • Damper link disconnection
  • Air inlet damper mechanically locked
  • Engine coolant temperature (high)
  • Air conditioning system temperature is set to MAX AC or air outlet mode set to defroster mode

PROCEDURE

1.

CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

(a) Check that the No. 1 blower damper servo sub-assembly is installed correctly.

OK:

The No. 1 blower damper servo sub-assembly is installed correctly.

NG

INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY CORRECTLY

OK

2.

CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes

OK:

DTC B1442 is not output.

NG

GO TO DTC B1442

OK

3.

READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine / Data List.

(e) Read the Data List according to the display on the Techstream.

Powertrain > Engine > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Coolant Temperature

Engine coolant temperature

Min.: -40°C (-40°F), Max.: 140°C (284°F)

75 to 100°C (167 to 212°F): After warming up

This is the engine coolant temperature.

HINT:

  • After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).
  • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
  • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
  • Check if the engine overheats if the value indicated is higher than 135°C (275°F).
Powertrain > Engine > Data List

Tester Display

Coolant Temperature

OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.

OK

REPLACE AIR CONDITIONER UNIT ASSEMBLY

NG

GO TO COOLING SYSTEM

    READ NEXT:

     No Cool Air Comes Out

    DESCRIPTION If warm air blows from the registers regardless of the temperature setting of the air conditioning system, the following suspected areas may be the cause. Symptom Factor No c

     Air Vent cannot be Switched

    DESCRIPTION If the air outlet mode does not change even though the air outlet display changes, the following suspected areas may be the cause. Symptom Factor Air outlet mode cannot be ch

     No Warm Air Comes Out

    DESCRIPTION If cool air blows from the registers regardless of the temperature setting of the air conditioning system, the following suspected areas may be the cause. Symptom Factor

    SEE MORE:

     Linear Solenoid Circuit (C1298)

    DESCRIPTION The 4WD ECU assembly receives signals from each sensor to control clutch fluid pressure for limiting the center differential operation, which distributes torque according to the driving conditions. DTC No. Detection Item DTC Detection Condition Trouble Area C1298

     Parking Support Brake function (rear-crossing vehicles)

    If a radar sensor detects a vehicle approaching from the right or left at the rear of the vehicle and the system determines that the possibility of a collision is high, this function will perform brake control to reduce the likelihood of an impact with the approaching vehicle. Examples of syste

    © 2023-2026 Copyright www.tocamry.com