Toyota Camry (XV70): Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT FENDER APRON SEAL RH
Click here .gif)
2. DRAIN ENGINE OIL
Click here
3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
| (a) Disengage the clamp to disconnect the wire harness protector. |
|
.png)
(b) Disconnect the engine oil pressure switch assembly connector.
| (c) Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly. |
|
.png)
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp to disconnect the wire harness protector.
*1 Wire Harness Protector
Installation
INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Adhesive: Toyota Genuine Adhesive 1344,
SEE MORE:
Drive Start Control
DESCRIPTION The drive start control is controlled by the ECM.
If the ECM determines that the shift lever and accelerator pedal are operated abnormally, engine output is restricted and, when necessary, a warning is displayed on the combination meter assembly.
CAUTION / NOTICE / HINT
HINT: Even
Right Front Wheel Speed Sensor Internal Electronic Failure (C050649)
DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC is stored.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C05064
© 2023-2026 Copyright www.tocamry.com
