Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (lubrication) / Oil Pressure Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

(a) Disengage the clamp to disconnect the wire harness protector.

*1

Wire Harness Protector

(b) Disconnect the engine oil pressure switch assembly connector.

(c) Start the engine.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - Switch body

Idling

10 kΩ or higher

Engine stopped

Below 1 Ω

If the result is not as specified, replace the engine oil pressure switch assembly.

(e) Connect the engine oil pressure switch assembly connector.

(f) Connect the wire harness protector.

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly. Adhesive: Toyota Genuine Adhesive 1344,

     Oil Pump

     Components

    COMPONENTS ILLUSTRATION *A w/ Stud Bolt *B w/o Stud Bolt *1 TIMING CHAIN CASE OIL SEAL *2 TIMING CHAIN COVER ASSEMBLY *3 OIL PUMP GASKET - -

    SEE MORE:

     Cooling System

    DESCRIPTION If the cooling effect of the air conditioning system is weak, the following suspected areas may be the cause. Symptom Factor Cooling effectiveness is poor Cooling response is slow Compressor assembly with pulley (compressor solenoid) malfunction*1

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY (a) Install a new fuel suction tube set gasket to the fuel tank assembly. (b) Set the fuel suction tube with pump and gauge assembly to the fuel tank assembly. NOTICE: Be careful not to bend the arm of the fuel se

    © 2023-2026 Copyright www.tocamry.com