Toyota Camry (XV70): Oil Pump
- Components
- Removal
- Disassembly
- Inspection
- Reassembly
- Installation
- Components
- Removal
- Disassembly
- Inspection
- Reassembly
- Installation
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*A w/ Stud Bolt
*B w/o Stud Bolt
*1 TIMING CHAIN CASE OIL SEAL
*2 TIMING CHAIN COVER ASSEMBLY
*3 OIL PUMP GASKET
- -
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during o
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE OIL PUMP RELIEF VALVE
(a) Using a 27 mm socket wrench, remove the oil pump relief valve plug from the oil pump cover.
(b) Remove the oil pump
SEE MORE:
ECM Communication (C124A00)
DESCRIPTION If the vehicle information stored by the skid control ECU (brake actuator assembly) does not match that sent from the ECM or a new skid control ECU (brake actuator assembly) is installed and the vehicle information has not been stored, this DTC is stored.
DTC No. Detection Item
Adjusting the set speed - Dynamic radar cruise
control with full-speed
range
Adjusting the set speed by the switch
To change the set speed, press the "+ RES" or "- SET" switch until the
desired set speed is displayed.
Increases the speed
(Except when the vehicle has been
stopped by system control in vehicle-
to-vehicle distance control
mode)
Decreases th
© 2023-2026 Copyright www.tocamry.com
