Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL V-RIBBED BELT
HINT:
When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.
| (a) Set the V-ribbed belt onto each pulley as shown in the illustration. |
|
(b) Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.
| (c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand. |
|
.png)
2. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
.gif)
3. INSTALL NO. 1 ENGINE UNDER COVER
Click here
4. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Click here
5. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here
READ NEXT:
A25a-fks Oil And Oil Filter
ComponentsCOMPONENTS ILLUSTRATION
*1 CENTER NO. 4 ENGINE UNDER COVER
- - ILLUSTRATION
*1 OIL FILTER SUB-ASSEMBLY
*2 OIL FILLER CAP SUB-ASSEMBLY
*3
Components
COMPONENTS ILLUSTRATION
*A for 2WD
*B for AWD
*1 IGNITION COIL ASSEMBLY
*2 NO. 1 ENGINE COVER SUB-ASSEMBLY
*3 SPARK PLUG
- -
N*m
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 (M-) - 2 (M+) 20°C (68°F)
0.3 to 100 Ω
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
■ Checking the engine oil
1. Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than 5 minutes for the oil to drain
back into the bottom of the engine.
2. Ho
