Toyota Camry (XV70): Initialization
INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Press the OFF switch.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(f) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Servomotor Initialization |
(g) Select Exit to complete initialization.
READ NEXT:
UTILITY REFRIGERANT HIGH PRESSURE HISTORY CLEAR
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON.
(c) Press the OFF switch. (d) Turn the Techstream on. (e) Enter the follow
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
*A w/o Seat Heater
*B w/ Seat Heater
HINT:
Check from the rear of the connector while it is connected to the air condit
SEE MORE:
COMPONENTS ILLUSTRATION
*1 PACKAGE TRAY TRIM PANEL ASSEMBLY
*2 REAR SEAT OUTER BELT ASSEMBLY LH
*3 REAR SEAT OUTER BELT ASSEMBLY RH
*4 REAR SEAT SHOULDER BELT HOLE COVER
Tightening torque for "Major areas involving basic vehicle performanc
INSTALLATION CAUTION / NOTICE / HINT
HINT: Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly. PROCEDURE
1. INSTALL NO. 1 PARKING BRAKE CABLE CLAMP
(a) Install a new No. 1 parking brake cable clamp to the No. 3 parking brake cable assembly