Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Parking Brake / Parking Brake Cable (for Rear Side) / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.
PROCEDURE
1. INSTALL NO. 1 PARKING BRAKE CABLE CLAMP
(a) Install a new No. 1 parking brake cable clamp to the No. 3 parking brake cable assembly.
2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Install the 3 bolts and nut, engage the clamp and install the No. 3 parking brake cable assembly.
|
*1 | No. 1 Parking Brake Cable Clamp |
- | - |
Torque:
Bolt :
6.0 N
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL TO PEDAL BRACKET
*2 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
*3 PARKING BRAKE PEDAL ASSEMBLY
*4 NO. 1 PARKING
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during p
SEE MORE:
4WD Control ECU Communication Stop Mode
DESCRIPTION
Detection Item Symptom
Trouble Area 4WD Control ECU Communication Stop Mode
Any of the following conditions are met:
Communication stop for "Four Wheel Drive Control" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Installation
INSTALLATION PROCEDURE 1. PRECAUTION
NOTICE:
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A c
© 2023-2026 Copyright www.tocamry.com
