Toyota Camry (XV70): Parking Brake Pedal
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL TO PEDAL BRACKET
*2 NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
*3 PARKING BRAKE PEDAL ASSEMBLY
*4 NO. 1 PARKING
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during p
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE PARKING BRAKE SWITCH ASSEMBLY
Click here
2. REMOVE PARKING PEDAL PAD (a) Remove the parking pedal pad from the parking brake pedal assembly.
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY
(a) Apply a light coat of lithium soap base glycol grease to a new O-ring.
(b) Install the
Crankshaft Position Sensor "A" Circuit Short to Ground (P033511,P033515)
DESCRIPTION The crankshaft position sensor system consists of a No. 1 crankshaft position sensor plate and Magneto Resistance Element (MRE) type sensor. The crankshaft position sensor plate has 34 teeth at 10° intervals (2 teeth are missing for detecting top dead center), and is installed on the cr
© 2023-2026 Copyright www.tocamry.com
