Toyota Camry owners & service manuals

Toyota Camry (XV70): Components

COMPONENTS

ILLUSTRATION

*1

INSTRUMENT PANEL TO PEDAL BRACKET

*2

NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY

*3

PARKING BRAKE PEDAL ASSEMBLY

*4

NO. 1 PARKING BRAKE CABLE ASSEMBLY

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf)

N*m (kgf*cm, ft.*lbf): Specified torque

ILLUSTRATION

*1

NO. 1 WIRE ADJUSTING NUT

*2

PARKING BRAKE PEDAL ASSEMBLY

*3

NO. 1 PARKING BRAKE CABLE ASSEMBLY

-

-

Non-reusable part

-

-

ILLUSTRATION

*1

PARKING BRAKE SWITCH ASSEMBLY

*2

PARKING PEDAL PAD

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during p

     Disassembly

    DISASSEMBLY PROCEDURE 1. REMOVE PARKING BRAKE SWITCH ASSEMBLY Click here 2. REMOVE PARKING PEDAL PAD (a) Remove the parking pedal pad from the parking brake pedal assembly.

     Reassembly

    REASSEMBLY PROCEDURE 1. INSTALL PARKING PEDAL PAD (a) Install the parking pedal pad to the parking brake pedal assembly. 2. INSTALL PARKING BRAKE SWITCH ASSEMBLY Click here

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) Clean the vacuum pump assembly installation bolt holes in the camshaft housing sub-assembly and cylinder head sub-assembly. (b) When using a new vacuum pump assembly: (1) Apply engine oil to the 2 O-rings which are installed to a new vac

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the Techstream to the DLC3. (2) Start the engine. (3) Turn the Techstream on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset. Powertrai

    © 2023-2026 Copyright www.tocamry.com