Toyota Camry (XV70): Reassembly
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Parking Brake / Parking Brake Pedal / Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL PARKING PEDAL PAD
(a) Install the parking pedal pad to the parking brake pedal assembly.
2. INSTALL PARKING BRAKE SWITCH ASSEMBLY
Click here
.gif)
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE PEDAL ASSEMBLY
(a) Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
(b) Install a new clip to the No. 1 par
Parking Brake Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 PARKING BRAKE PEDAL ASSEMBLY
*2 PARKING BRAKE SWITCH ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque
- - RemovalREMO
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3 with the ignition switch off.
(b) Start the engine and run it at idle. (c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Brake / Active Test. HINT:
Refer to the Techstream operator
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below. Necessary Procedures After Parts Removed/In
© 2023-2026 Copyright www.tocamry.com
