Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

PROCEDURE

1. INSTALL PARKING BRAKE PEDAL ASSEMBLY

(a) Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.

(b) Install a new clip to the No. 1 parking brake cable assembly.

(c) Temporarily install a new No. 1 wire adjusting nut to the No. 1 parking brake cable assembly.

NOTICE:

If the No. 1 wire adjusting nut has been removed from the No. 1 parking brake cable assembly, replace the No. 1 wire adjusting nut with a new one.

(d) Bend the parking brake pedal assembly claw.

2. CONNECT PARKING BRAKE PEDAL ASSEMBLY

(a) Install the parking brake pedal assembly to the vehicle body with the 2 nuts.

Torque:

15.5 N

    READ NEXT:

     Parking Brake Switch

    ComponentsCOMPONENTS ILLUSTRATION *1 PARKING BRAKE PEDAL ASSEMBLY *2 PARKING BRAKE SWITCH ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMO

     Parking Brake System (w/o Electric Parking Brake System)

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr

    SEE MORE:

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below. Necessary Procedures After Parts

     Installation

    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rear axle carrier sub-assembly to the rear shock abso

    © 2023-2026 Copyright www.tocamry.com