Toyota Camry (XV70): Disassembly
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Parking Brake / Parking Brake Pedal / Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE PARKING BRAKE SWITCH ASSEMBLY
Click here .gif)
2. REMOVE PARKING PEDAL PAD
(a) Remove the parking pedal pad from the parking brake pedal assembly.
READ NEXT:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL PARKING PEDAL PAD
(a) Install the parking pedal pad to the parking brake pedal assembly.
2. INSTALL PARKING BRAKE SWITCH ASSEMBLY Click here
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE PEDAL ASSEMBLY
(a) Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
(b) Install a new clip to the No. 1 par
Parking Brake Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 PARKING BRAKE PEDAL ASSEMBLY
*2 PARKING BRAKE SWITCH ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque
- - RemovalREMO
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU TERMINALS OF ECU
*a Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))
- -
HINT:
As a waterproof connector is used for the brake actuator assembly, voltage and waveform inspections cannot be performed with the connector c
Right Rear Wheel Speed Sensor Signal Stuck High (C051224)
DESCRIPTION Refer to DTC C051212 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C051224 Right Rear Wheel Speed Sensor Signal Stuck High
The speed sensor signal is not within the specified range for 5 seconds or more.
Rear speed sensor
© 2023-2026 Copyright www.tocamry.com
