Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL PUMP CONTROL ECU BRACKET
(a) Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.
Torque:
4.5 N·m {46 kgf·cm, 40 in·lbf}
2. INSTALL FUEL PUMP CONTROL ECU
(a) Install the fuel pump control ECU to the vehicle body with the nut.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(b) Connect the 2 fuel pump control ECU connectors.
3. INSTALL ROOM PARTITION BOARD LH
Click here
.gif)
4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
Click here
5. INSTALL REAR SEAT SHOULDER BELT HOLE COVER
Click here
6. INSTALL INNER ROOF SIDE GARNISH LH
Click here
7. INSTALL INNER ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
8. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
Click here
9. CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL CENTER STOP LIGHT SET
Click here
11. INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
Click here
12. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type)
Click here
13. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
HINT:
Use the same procedure as for the LH side.
14. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)
HINT:
Use the same procedure as for the LH side.
15. INSTALL REAR SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
Click here
16. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
Click here
17. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
Click here
18. INSTALL REAR SEAT HEADREST ASSEMBLY LH (w/ Removable Headrest)
Click here
19. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
Click here
20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
21. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
22. INSPECT SRS WARNING LIGHT
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FUEL SENDER GAUGE ASSEMBLY
*2 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL OIL PUMP ROTOR SET
(a) Coat the drive rotor and driven rotor with engine oil and place them into the timing chain cover assembly with the rotor marks facing up. Check that the rotors rotate smoothly.
*a Rotor Mark
2. I
Installation
INSTALLATION PROCEDURE 1. INSTALL CLEARANCE WARNING ECU ASSEMBLY
(a) Engage the claw to install the clearance warning ECU assembly as shown in the illustration.
Install in this Direction 2. INSTALL ECU INTEGRATION BOX RH
Click here 3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSE
