Toyota Camry owners & service manuals

Toyota Camry (XV70): Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.

CHECK SATELLITE RADIO

(a) Check radio condition.

Result

Proceed to

Broadcast cannot be selected.

A

Broadcast can be selected, but selection cannot be memorized.

B

A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

2.

CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

OK

END (ONLY 36 CHANNELS CAN BE PRESET)

NG

3.

CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

4.

ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    READ NEXT:

     Weather and traffic information cannot be obtained

    CAUTION / NOTICE / HINT NOTICE: When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicl

     Noise Occurs

    PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source can be determined.

     No Sound can be Heard from Speakers

    PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio system returns to

    SEE MORE:

     Pressure Control Solenoid "A" Circuit Short to Battery (P074512)

    DESCRIPTION Changing gears is performed by the ECM turning the solenoid (SL1, SL2, SL3, SL4, SL5 and SL6) valves on and off. If an open or short occurs in any of the solenoid valve circuits, the ECM controls the remaining normal solenoid valves to allow the vehicle to be driven. If all of the sole

     Stop Lamp Relay Actuator Stuck Off (C13807F)

    DESCRIPTION Refer to DTC C13807E. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C13807F Stop Lamp Relay Actuator Stuck Off When the voltage at the +BS terminal is between 10 V or more and the stop light control relay (stop light switch ass

    © 2023-2024 Copyright www.tocamry.com