Toyota Camry (XV70): Parking Brake Cable (for Rear Side)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Parking Brake / Parking Brake Cable (for Rear Side)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 REAR CENTER SEAT OUTER BELT ASSEMBLY
*2 REAR SEAT CUSHION ASSEMBLY
*3 REAR SEAT CUSHION LOCK HOOK
*4 REAR SEAT INNER BELT ASSEMBLY RH
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during N
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT: Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly. PROCEDURE
1. INSTALL NO. 1 PARKING BRAKE CABLE
SEE MORE:
Cooling System
DESCRIPTION If the cooling effect of the air conditioning system is weak, the following suspected areas may be the cause.
Symptom Factor
Cooling effectiveness is poor
Cooling response is slow
Compressor assembly with pulley (compressor solenoid) malfunction*1
Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here
HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the engine switch is then
© 2023-2026 Copyright www.tocamry.com
